Monday, May 11, 2015

Displaying FullSizeRender.jpg
  1. When running your final piece you need to maintain the same consistency throughout the batches. 
Displaying FullSizeRender.jpg
This is the finished piece.

Displaying FullSizeRender.jpg

Displaying FullSizeRender.jpg
After designing my piece I ran an additional piece that is slightly smaller to go underneath my molding so that I will have a thinner and lighter finished product 
Displaying FullSizeRender.jpg
Once I began carving the profile I started one the longest side. Once the profile was scribed in I could clearly see where to carve. 
Displaying FullSizeRender.jpg
The first step to designing a stone is to first draw the profile from every angle.
Displaying FullSizeRender.jpg
My classmate Daniella Helline carved half of the column and i carved the other. when we out them together they lined up to create the finished product.

Displaying FullSizeRender.jpg

When returning the profile around a corner the corner should be a straight line when you look at it straight on. As you can see  in this picture, where the line is no longer straight is where i have not carved the profile yet.

Tabby At Historic Fort Dorchester

Displaying IMG_8282.JPG
after the first layer set, we took off the mold and reconstructed it on top to build the wall higher.
Displaying IMG_8275.JPG
Once the tabby was mixed we poured it into a wooden mold we had built into the ground.
Displaying FullSizeRender.jpg
Tabby is built out of lime and oyster shells. the traditional way to go about retrieving the lime is to burn oyster shells. Tabby is not common today, there are only a handful of people who know how to do it. in this particular picture we are mixing the oysters shells, quick lime, and water. Quick lime can be dangerous because once it touches moisture it becomes extremely hot.

Displaying IMG_8277.JPG

Friday, February 20, 2015

A cabin in the woods

My Father and I building our dream cabin by hand. Located in the Uwharrie National Forest.

finished the hand-dug foundation!





It's finally coming together!


Tuesday, December 16, 2014

Stone carved Chimney Topper


This semester my classmates and I are carving an eight piece chimney topper building arts house located in downtown Charleston. once completed the chimney topper will be roughly 5x5ft. This image shows the profile of the ovalo design for the topper.





After all four corners and four middle sections are out together a 5ftx5ft stone was created

Stone Carving


This is an example of basic stone carving and splitting with a tool finish

Sunday, September 7, 2014

Creating a mold step 1:

The first step to creating a mold from existing plaster is stoping the paint. Here we are stripping the paint from a small section allowing us to create a mold that will go around the top of the new wall in this room.